|
|
Line 47: |
Line 47: |
| \end{alignat} | | \end{alignat} |
| </math> | | </math> |
− | We note that:
| + | Where we used: |
| ::<math> | | ::<math> |
| \begin{alignat}{2} | | \begin{alignat}{2} |
| + | \sin( \arctan[u]) & = \frac{u}{\sqrt{1+u^2}} \\ |
| + | \sin \theta_f & = \sin( \arctan [x/d] ) \\ |
| + | & = \frac{x/d}{\sqrt{1 + (x/d)^2}} \\ |
| + | & = \frac{x}{\sqrt{d^2+x^2}} |
| + | \end{alignat} |
| + | </math> |
| + | |
| + | And, we further note that: |
| + | ::<math> |
| + | \begin{alignat}{2} |
| + | \cos( \arctan[u]) & = \frac{1}{\sqrt{1+u^2}} \\ |
| \cos \theta_f & = \frac{1}{\sqrt{1 + (x/d)^2}} \\ | | \cos \theta_f & = \frac{1}{\sqrt{1 + (x/d)^2}} \\ |
| & = \frac{d^2}{\sqrt{d^2+x^2}} | | & = \frac{d^2}{\sqrt{d^2+x^2}} |
Revision as of 18:28, 29 December 2015
The q-vector in fact has three components:
Consider that the x-ray beam points along +y, so that on the detector, the horizontal is x, and the vertical is z. We assume that the x-ray beam hits the flat 2D area detector at 90° at detector (pixel) position . The scattering angles are then:
where is the sample-detector distance, is the out-of-plane component (angle w.r.t. to y-axis, rotation about x-axis), and is the in-plane component (rotation about z-axis). The alternate angle, , is the elevation angle in the plane defined by . Also note that the full scattering angle is:
The momentum transfer components are:
Check
As a check of these results, consider:
Where we used:
And, we further note that:
Continuing: