Difference between revisions of "Tutorial:Qualitative inspection"
KevinYager (talk | contribs) (Created page with "TBD ==Amount of Order== TBD ==Peak Width== In scattering, sharp peaks correspond to large grain sizes, whereas broad peaks correspond to small grain sizes. This can be quant...") |
(No difference)
|
Revision as of 13:19, 11 June 2014
TBD
Amount of Order
TBD
Peak Width
In scattering, sharp peaks correspond to large grain sizes, whereas broad peaks correspond to small grain sizes. This can be quantified through a Scherrer grain size analysis. Even qualitatively, however, it is usually easy to judge how well-ordered a material is based purely on peak widths. Consider a highly disordered system, such as an amorphous polymer. The polymer chains likely have some preferred chain-packing distance, but the 'lattice' only repeats once or twice before decorrelating; i.e. there isn't a well-defined crystal with well defined grain boundaries. In such a case one would see a very broad halo. In even more disordered systems, only diffuse scattering would be seen (this can be thought of as the ultimate limit of a broad peak).
On the other hand, extremely sharp peaks indicate that the lattice repeats in a well-correlated well over very large distances.
Scattering Intensity
The scattering intensity (counts on the x-ray detector) scales with the amount of scattering material. Thus, a bigger sample yields a stronger scattering signal. (Of course if you try to scatter through a sample that is too thick, absorption will at some point instead reduce the signal.) For a given scattering volume, the intensity of the scattering can be thought of as a probe of the fraction of the material in the given state/phase/configuration. I.e. if a given peak is stronger in one sample vs. another, then this means that the phase (crystal form, etc.) corresponding to that peak appears more frequently in that sample. One must be careful, however, as many other things are implicated in peak heights (orientation, disorder, etc.).
Note that in general, well-ordered systems will appear to scatter more strongly than weakly-ordered systems. A broad scattering peak (small grains) will have lower maximum intensity than a sharp scattering peak (big grains). More generally, periodically ordered structures give rise to scattering events, whereas homogeneous systems do not scattering the incident radiation.
Higher Orders
TBD