Difference between revisions of "Geometry:TSAXS 3D"

From GISAXS
Jump to: navigation, search
(Total scattering)
(Out-of-plane only)
Line 80: Line 80:
 
\begin{alignat}{2}
 
\begin{alignat}{2}
 
q & = 2 k \sin \left( \alpha_f /2 \right) \\
 
q & = 2 k \sin \left( \alpha_f /2 \right) \\
     & = 2 k \sqrt{ \frac{1- \cos(\theta_f)}{2} } \\
+
     & = 2 k \sqrt{ \frac{1- \cos(\alpha_f)}{2} } \\
    & = 2 k \sqrt{ \frac{1}{2} \left( 1 - \frac{1}{\sqrt{1+(x/d)^2}}  \right) } \\
+
     & = 2 k \sqrt{ \frac{1}{2} \left( 1 - \frac{d}{\sqrt{d^2+z^2}} \right) }
     & = 2 k \sqrt{ \frac{1}{2} \left( 1 - \frac{d}{\sqrt{d^2+x^2}} \right) }
 
 
\end{alignat}
 
\end{alignat}
 
</math>
 
</math>

Revision as of 12:00, 30 December 2015

In transmission-SAXS (TSAXS), the x-ray beam hits the sample at normal incidence, and passes directly through without refraction. TSAXS is normally considered in terms of the one-dimensional momentum transfer (q); however the full 3D form of the q-vector is necessary when considering scattering from anisotropic materials. The q-vector in fact has three components:

This vector is always on the surface of the Ewald sphere. Consider that the x-ray beam points along +y, so that on the detector, the horizontal is x, and the vertical is z. We assume that the x-ray beam hits the flat 2D area detector at 90° at detector (pixel) position . The scattering angles are then:

where is the sample-detector distance, is the out-of-plane component (angle w.r.t. to y-axis, rotation about x-axis), and is the in-plane component (rotation about z-axis). The alternate angle, , is the elevation angle in the plane defined by .

Total scattering

The full scattering angle is defined by a right-triangle with base d and height :

The total momentum transfer is:

Given that:

We can also write:

Where we take for granted that q must be positive.

In-plane only

If (and ), then , , and:

The other component can be thought of in terms of the sides of a right-triangle with angle :

Summarizing:

Out-of-plane only

If , then , , and:

Components

The momentum transfer components are:

Check

As a check of these results, consider:

Where we used:

And, we further note that:

Continuing: